KEMET C0805F103K5RACTU Datasheet & Stock

The F or J series ceramic Open Mode Capacitor in X7R dielectric are designed to minimize the probability of a low IR or short-circuit condition when forced to failure in a board stress flex situation. The open mode capacitor may experience a drop in capacitance, however, a short is unlikely because a crack will not typically propagate across counter electrodes within the device's active area. Since there will not be any current leakage associated with a typical open mode flex crack, there is no localized heating and therefore little chance for a catastrophic and potentially costly failure event. Driven by the demand for a more robust and reliable component, the open mode capacitor was designed for critical applications where higher operating temperatures and mechanical stress are a concern. These capacitors are widely used in automotive circuits and general electronic applications.




Open mode/fail open design

Mid to high capacitance flex mitigation

Non-polar device, minimizing installation concerns

Capacitance offerings ranging from 1000pF to 6.8μF

EIA 0805, 1206, 1210 and 1812 case sizes available

DC voltage ratings of 16, 25, 50, 100 and 200V

Available capacitance tolerances of ±5%, ±10% and ±20%

100% Pure matte tin-plated termination finish allowing for excellent solderability