Amphenol Communications Solutions 10127818-222LF Datasheet & Stock

The Minitek Pwr 4.2 series Board or Wire-to-Board Connector are designed for power application with current rating up to 9A per circuit. It is available for dual row and 2 to 24 circuits, for wire-to-board, wire-to-wire and wire-to-panel mount application. The crimp, snap-in header and receptacle contacts are used to terminate 28 to 16AWG wires. The header and receptacle housings allow wire-to-wire and wire-to-board configurations. Crimping and removal tools are available for wire harness assembly. Header assemblies for wire-to-board in interconnections include vertical and right angle components. These wave soldering headers are available in through-hole configurations. A right angle version cable receptacle is also available.




Fully isolated terminals

Prevents terminals from potential damage during operation

Positive locking on HSG with low thumb latch operation

Polarized mating geometry

Scoop-proof housings

Fully polarized housings

High retention force in HSG

Low insertion force for installation of crimped terminal

UL94V-0 Flammability

Vertical and right-angle PCB headers for wave soldering application





Interchangeable and compatible with Molex Micro-Fit™

Wire-to-wire, wire-to-board and wire-to-panel connectors with 4.2mm centerline

Meet environmental, health and safety requirements

Flexible applications in various situations

Supports various 1.6mm PCB applications

Well secures terminals in housings

Prevents accidental mis-mating

1000MΩ Insulation resistance (minimum)

10mΩ Contact resistance (maximum)

30 Cycles durability





Applications


Consumer Electronics,

Sensing & Instrumentation,

Medical,

Lighting,

Communications & Networking,

Computers & Computer Peripherals,

Industrial