FLUKE 80I-110S CAL Datasheet & Stock

The 80I-110S CAL from Fluke is an AC/DC current clamp with BNC terminated lead. It is designed to provide safe, high accuracy measurements for a wide range of applications. The built-in safety features such as 600Vrms rating at input jaws, output cable and BNC connector enhance work safety in industrial and commercial power distribution systems. The probe is shielded for high noise immunity to prevent unwanted noise when troubleshooting around noise generating devices like adjustable speed motor drives and ignition systems. The wide measurement range with a high fidelity millivolt output gives full advantage of high resolution oscilloscope displays. The DC to 100KHz broad band frequency response supports wide range of applications. The 80I-110S is compatible with any Fluke ScopeMeter test tool, power harmonics analyzer, oscilloscope, multimeter or other voltage measurement device that has BNC input connectors (for meter convert banana plugs to BNC connector with adapter PM9081/001).




Calibrated AC/DC current clamp, easy to take measurements in tight spot

10A AC/DC, 100A AC/DC nominal current & 0.1A to 10A AC/DC, 1A to 100A AC/DC continuous current

Maximum non destructive current of 140A at 2KHz, lowest measurable current of 0.1A

3% + 50mA (at 10A) (% reading+floorspec) basic accuracy, reproduces current waveforms as they occur

0 to 100KHz useful bandwidth (-3dB), 100mV/A (10A range), 10mV/A (100 A range) output signals

Working voltage of 600VACrms on (Cat II per IEC 1010-1), 300VACrms on (Cat III per IEC 1010-1)

Input load impedance of greater than 1Mohm in parallel with up to 100pF, narrow jaw design

IEC 1010, CSA-C22.2 No. 1010-1, CAT II 600V, CAT III 300V and pollution degree 2 safety ratings

0°C to 50°C operating temperature, 12.5mm maximum jaw opening, 9V battery (55h service life)

Dimension is 67mm x 231mm x 36mm, weight is 330g (battery included) and 1.6m output cable





Applications


Test & Measurement,

Industrial