Grayhill 62H3030H9040C High Torque Concentric Encoder

Grayhill 62H3030H9040C High Torque Concentric Encoder Specifications:

• rotational_torque: 5.0 in-oz +/- 1.5 in-oz initial
• shaft_push_out_force: 45 lbs minimum
• mounting_torque: 15 in-lbs maximum
• terminal_strength: 15 lbs cable pull-out force minimum
• operating_speed: 100 RPM maximum
• coding: 2-bit quadrature coded output
• operating_voltage: 5.0 ±.25 Vdc
• supply_current: 50 mA maximum@5.0 Vdc
• logic_high: 3.0 Vdc minimum
• logic_low: 1.0 Vdc maximum
• mechanical_life: 1,000,000 cycles minimum
• minimum_sink_current: 2.0 mA for 5 Vdc
• power_consumption: 150mW maximum
• output: open collector phototransistor
• logic_rise_fall_times: less than 30 mS maximum
• pushbutton_ratings_at_5vdc_10ma: resistive
• pushbutton_contact_resistance: less than 10 ohms (TTL or CMOS compatible)
• pushbutton_life: 3 million actuations minimum
• pushbutton_voltage_breakdown: 250 Vac between mutually insulated parts
• pushbutton_contact_bounce: less than 4 mS at make and less than 10 mS at break
• pushbutton_actuation_force: 1100 ±300g
• shaft_travel: .020±.010 inch
• operating_temperature_range: -40°C to 85°C
• storage_temperature_range: -55°C to 100°C
• vibration_resistance: Harmonic motion with amplitude of 15G, within a varied 10 to 2000 Hz frequency for 12 hours
• mechanical_shock_test_1: 100G, 6 mS, half sine, 12.3 ft/s
• mechanical_shock_test_2: 100G, 6 mS, sawtooth, 9.7 ft/s
• relative_humidity: 90–95% at 40°C for 96 hours
• code_housing_material: Reinforced thermoplastic
• shaft_material: Stainless Steel
• bushing_material: Zinc casting
• pushbutton_actuator_material: Zytel 70G33L
• shaft_retaining_rings_material: Stainless steel
• detent_spring_material: Stainless steel
• detent_ball_material: Stainless steel
• detent_section_material: Hiloy 610
• pcb_material: NEMA grade FR-4 gold over nickel or palladium
• terminals_material: Brass, tin-plated
• mounting_hardware_material: Brass, nickel-plated nut and zinc-plated spring steel with clear trivalent chromate finish lockwasher
• rotor_material: Thermoplastic
• pushbutton_dome_material: Stainless steel
• phototransistor_material: Planar Silicon NPN
• infrared_emitter_material: Gallium aluminum arsenide
• flex_cable_material: 28 AWG, stranded/top coated wire, PVC coated on .050 or .100" centers
• header_pins_material: Brass, tin-plated
• spacer_material: Hiloy 610
• shim_material: Stainless Steel
• backplate_strain_relief_material: Stainless steel
• lockwashers_material: Stainless steel
• hex_nuts_material: Stainless steel
• studs_material: Stainless steel