MEGGER DLRO600-NLS Datasheet & Stock

Megger DLRO600-NLS Offers

Features

Small and weighs less than 33 lbs
Test currents from 10A to 600A DC
0.1 µohms best resolution
On-board memory for up to 300 test results and notes
RS232 port to download stored results or for real time output to a printer
Supplied complete with 16.4 ft. test leads and download software


Applications

Circuit breaker contacts
Switch contacts
Busbar joints



Operates in One of Three Modes
Continuous mode is provided for users who wish to monitor a resistance over a period of time. Connect the test leads, select the test current and press the TEST button. The DLR600 will pass a current continuously, and measure the resulting voltage at 2-second intervals, until the test button is pressed to stop the test or the test circuit is interrupted.
In Normal mode you connect the leads, select the test current and press the TEST button. The test current will ramp up to the desired level, hold for 2 seconds and then ramp down. The whole process takes approximately 7 seconds.
In Auto mode select the desired current, connect the current leads and press the TEST button. The TEST lamp will flash to show that the DLRO600 is ready to carry out a test. As soon as the potential leads are connected, a test will start. To repeat a test, simply break contact with the voltage probes and remake contact.