RASPBERRY-PI RASPBERRY PI PICO Datasheet & Stock

Raspberry Pi Pico is designed as our low-cost breakout board for RP2040. It pairs RP2040 with 2MB of Flash memory, and a power supply chip supporting input voltages from 1.8-5.5V. This allows you to power your Pico from a wide variety of sources, including two or three AA cells in series, or a single lithium-ion cell. Pico provides a single push button, which can be used to enter USB mass-storage mode at boot time and also as a general input, and a single LED. It exposes 26 of the 30 GPIO pins on RP2040, including three of the four analogue inputs, to 0.1”-pitch pads; you can solder headers to these pads or take advantage of their castellated edges to solder Pico directly to a carrier board. Volume customers will be able to buy pre-reeled Pico units: in fact we already supply Pico to our Approved Resellers in this format.




RP2040 microcontroller chip designed by Raspberry Pi in the United Kingdom

Dual-core ARM Cortex M0+ processor, flexible clock running up to 133 MHz

Castellated module allows soldering direct to carrier boards

USB 1.1 Host and Device support

Low-power sleep and dormant modes

Drag & drop programming using mass storage over USB

2×SPI, 2×I2C, 2×UART, 3×12-bit ADC, 16×controllable PWM channels

Accurate clock and timer on-chip, temperature sensor

Accelerated floating point libraries on-chip

8×Programmable IO (PIO) state machines for custom peripheral support