TDK InvenSense MPU6000 DEV BOARD Datasheet & Stock

The MPU6000 DEV BOARD is an development board for MPU-6000 and MPU6050, a 6-axis motion processing IC that eliminates the package level gyro/accel cross axis misalignment associated with discrete solutions. The devices combine a 3-axis gyroscope and a 3-axis accelerometer on the same silicon die together with an on-board digital motion processor (DMP) capable of processing complex 9-axis motion fusion algorithms. The parts integrated 9-axis motion fusion algorithms access external magnetometers or other sensors through an auxiliary I2C bus, allowing the devices to gather a full set of sensor data without intervention from the system processor. MPU-6000 supports SPI at up to 20MHz, in addition to I2C, and has a single supply pin, VDD, which is both the devices logic reference supply and the analogue supply for the part.




Digital output of 6 axis or 9 axis motion fusion data in rotation matrix, quaternion, euler angle

Tri axis angular rate sensor with a sensitivity up to 131LSBs/dps

Tri axis accelerometer with a programmable full scale range of ±2g, ±4g, ±8g and ±16g

Digital output temperature sensor

Embedded algorithms for run time bias and compass calibration. No user intervention required

Digital input on FSYNC pin to support video electronic image stabilization and GPS

Gyro operating current 3.6mA (full power, gyro at all rates)

On chip timing generator with ±1% frequency variation over full temperature range

User self test

5µA full chip idle mode supply current




Warnings
Market demand for this product has caused an extension in leadtimes. Delivery dates may fluctuate. Product exempt from discounts.